Module Design Guide

If other sensors or actuators are needed to accomplish your specific project, it is possible to develop them independently. The following shows important pin locations on the 30-pin minature connector attached to the fleible circuit, where the module would be mounted:

• Pins 1 and 16 are for the voltage supply
• Pins 2 and 17 are ground
• For SPI mode
  • Pin 4 is the chip select
  • Pin 11 is MISO

• Pin 12 is MOSI
• Pin 13 is CLK

• For I2C mode

• Pin 9 is Data
• Pin 10 is Clock